Buttons F1～F5 correspond to the functions of the five buttons in the interface respectively.
1 Zero: In the main interface, press the corresponding F1 button to reset the force to zero.
2 Erase: In the main interface, press the corresponding F2 button when the test is stopped to erase the last test result.
3 Up: In the main interface, when the test is stopped, press the corresponding F3 button for a slow rise, and press it again for a fast rise
4 Down: In the main interface, when the test is stopped, press the corresponding F4 button for a slow downward, and press it again for a fast downward.
5 Get-P: In the main interface, press the corresponding F5 button when the test starts:
6 The method to enter the next interface:
First, use F1~F5 to directly enter the next interface.
Second, select the sub-interface in the interface with the selection box, and press ENTER.
Third, press EXIT to exit the sub-interface and return to the previous interface.
7 Press the TEST button in the interface to which the calibration belongs to play a rising role.
Basic operation before use:
1 Please set the test parameters before starting the test, otherwise the system will use the last parameters by default.
2 Please check and save the parameters after setting (it will be automatically saved in some interfaces), and the system will automatically use the saved parameters when the system is turned on next time;
3 Gain 1 is related to the sensitivity of the sensor, and can be matched with the hardware dial switch;
4 The position of the red dial switch has changed, and the hardware zero position should be re-calibrated.
